Browsing by Subject "twin"
Now showing 1 - 2 of 2
Results Per Page
Sort Options
Item Nanoscale Growth Twins in Sputtered Copper Films(2011-08-08) Anderoglu, OsmanThe focus of this research is the development of high strength, high conductivity copper films. Pure copper is soft and traditional strengthening mechanisms cause substantial decrease in conductivity. To address the challenge, epitaxial nanotwinned copper films are synthesized on HF etched Si (110) substrates. These films show high hardness (~ 2.8 GPa) due to high density of coherent twin boundaries (CTBs) which effectively block the motion of dislocations similar to grain boundaries (GBs). Resistivity of CTBs is calculated to be an order of magnitude lower than that of GBs. Hence, conductivity of nanotwinned copper is still comparable to that of pure copper. In addition, it is shown that average twin spacing can be controlled by adjusting deposition rate. Analytical studies together with experimental evidence show that nanotwins can improve the strength-to-resistivity ratio significantly in copper. In general, nanocrystalline metals suffer from low ductility. To study plastic deformation via rolling, thick polycrystalline nanotwinned copper foils are sputtered on SiO2 and then peeled off the substrate. Despite the high strength, room temperature rolling experiments show that nanotwinned copper films exhibit stable plastic flow with no shear localization or fracture even at thickness reduction of over 50%. Postdeformation studies of microstructure reveals that the plastic deformation is facilitated by the migration of CTBs normal to the twin boundary plane due to the glide of twinning dislocations in the twin plane. X-ray pole figure measurements show insignificant out of plane rotation as a result of 50% rolling thickness reduction. Thermal stability of nanocrystalline metals is also a concern. Free standing nanotwinned polycrystalline copper films show remarkable thermal stability after annealing at 800 degrees C. The driving force for twin growth is much lower than that for grain coarsening because the energy stored in CTBs is an order of magnitude lower than that of GBs. As a result, the average twin spacing stays below 20 nm after annealing. Such high thermal stability of nanotwins leads to the retention of hardness of 2.2 GPa. Low energy twin boundary may provide a unique way to achieve both high strength and high temperature thermal stability in certain metallic materials.Item Radiation Damage in Nanostructured Metallic Films(2013-04-15) Yu, KaiyuanHigh energy neutron and charged particle radiation cause microstructural and mechanical degradation in structural metals and alloys, such as phase segregation, void swelling, embrittlement and creep. Radiation induced damages typically limit nuclear materials to a lifetime of about 40 years. Next generation nuclear reactors require materials that can sustain over 60 - 80 years. Therefore it is of great significance to explore new materials with better radiation resistance, to design metals with favorable microstructures and to investigate their response to radiation. The goals of this thesis are to study the radiation responses of several nanostructured metallic thin film systems, including Ag/Ni multilayers, nanotwinned Ag and nanocrystalline Fe. Such systems obtain high volume fraction of boundaries, which are considered sinks to radiation induced defects. From the viewpoint of nanomechanics, it is of interest to investigate the plastic deformation mechanisms of nanostructured films, which typically show strong size dependence. By controlling the feature size (layer thickness, twin spacing and grain size), it is applicable to picture a deformation mechanism map which also provides prerequisite information for subsequent radiation hardening study. And from the viewpoint of radiation effects, it is of interest to explore the fundamentals of radiation response, to examine the microstructural and mechanical variations of irradiated nanometals and to enrich the design database. More importantly, with the assistance of in situ techniques, it is appealing to examine the defect generation, evolution, annihilation, absorption and interaction with internal interfaces (layer interfaces, twin boundaries and grain boundaries). Moreover, well-designed nanostructures can also verify the speculation that radiation induced defect density and hardening show clear size dependence. The focus of this thesis lies in the radiation response of Ag/Ni multilayers and nanotwinned Ag subjected to charged particles. The radiation effects in irradiated nanograined Fe are also investigated for comparison. Radiation responses in these nanostructured metallic films suggest that immiscible incoherent Ag/Ni multilayers are more resistant to radiation in comparison to their monolithic counterparts. Their mechanical properties and radiation response show strong layer thickness dependence in terms of radiation hardening and defect density. Coherent twin boundaries can interact with stacking fault tetrahedral and remove them effectively. Twin boundaries can actively absorb radiation induced defects and defect clusters resulting in boundary migration. Size dependence is also found in nanograins where fewer defects exhibit in films with smaller grains.