Browsing by Subject "reflection coefficients"
Now showing 1 - 2 of 2
Results Per Page
Sort Options
Item An AVO method toward direct detection of lithologies combining P-P and P-S reflection data(Texas A&M University, 2004-09-30) Carcuz Jerez, Juan Ramon de JesusI here present a combined AVO analysis of P-P and P-S reflection data whose objective is to improve the identification of lithology by estimating the specific values of Poisson's ratio, [sigma], for each rock formation in a given geological model, rather than a contrast between formations. Limited knowledge on the elastic parameters of a given rock formation and difficulty regarding the availability and processing of P-S data constitute hindrances of lithology identification. Considering that ocean bottom seismology (OBS) has aided in solving the problem of P-S data availability, limited information on elastic parameters is still a challenge, and the focus of this thesis. The present analysis is based on Zoeppritz' solution for the P-P and P-S reflection coefficients, RPP and RPS, with a slight modification. We used the normalized P-S reflection coefficient; i.e., R'PS = RPS / sin [theta] for [theta] > 0, instead of RPS, where [theta] is the incident angle. By normalizing RPS, we avoid dealing with the absence of converted S-waves at small incident angles and enhance the similar linear behavior of the P-P and normalized P-S reflection coefficients at small angles of incidence. We have used the linearity of RPP and R'PS at angles smaller than 35 degrees to simultaneously estimate the average VP/VS ratio, the contrasts of P- and S-wave velocities, and the contrast of density. Using this information, we solve for Poisson's ratio of each formation, which may enable lithology discrimination. The feasibility of this analysis was demonstrated using nonlinear synthetic data (i.e., finite-difference data). The results in estimating Poisson's ratio yielded less than 5 percent error. We generalize this new combined P-P and P-S AVO analysis for dipping interfaces. Similarly to the nondipping interface case, our derivations show that the amplitude variation with offset (AVO) of P-P and P-S for a dipping interface can be cast into intercepts and gradients. However, these intercepts and gradients depend on the angle of the dipping interface. Therefore, we further generalize our analysis by including a migration step that allows us to find the dipping angle. Because seismic data is not available in terms of RPP and R'PS, this process includes recovery of reflection coefficients after migrating the data and correcting for geometrical spreading, as done by Ikelle et al. (1986 and 1988). The combination of all of these steps, namely geometrical-spreading correction, migration, and AVO analysis, is another novelty of this thesis, which leads to finding the specific values of Poisson's ratio of each rock formation directly from the seismic data.Item Wave Interactions with Arrays of Bottom-Mounted Circular Cylinders: Investigation of Optical and Acoustical Analogies(2010-10-12) Baquet, AldricWave scattering by arrays of cylinders has received special attention by many authors and analytical solutions have been derived. The investigation of optical and acoustical analogies to the problem of interaction of water waves with rigid and flexible cylinder arrays is the main focus of this thesis. In acoustics, a sound may be attenuated while it propagates through a layer of bubbly liquid. In fact, if the natural frequency of the bubbles is in the range of the wave periods, the attenuation becomes more evident. The ultimate objective of the research described herein is to determine if this phenomenon may also be found in the interaction between water waves and arrays of flexible cylinders. In a first approach, arrays of rigid cylinders are studied in shallow water. The array is treated as an effective medium, which allows for the definition of reflection and transmission coefficients for the array, and theories from Hu and Chan (2005) associated with the Fabry-Perot interferometer are compared against direct computations of wave scattering using the commercial code WAMIT. Reflection and transmission coefficients from WAMIT are evaluated by applying a Maximum Likelihood Method. The results from WAMIT were found to be in good agreement with those obtained from the effective medium theory. Due to observed inconsistencies for short wave periods and small incident angles, the effective width of the medium is defined and corrected. For the case of a flexible cylinder, generalized modes corresponding to deformations of the cylinder's surface are formulated and added to WAMIT's subroutine. Equations of motion are derived from the theory of vibration for thin shells and mass and stiffness matrices are defined. The objective is to maximize wave attenuation from the array of flexible cylinders. Therefore, the natural periods of the "breathing" mode for these cylinders is set in the range of the studied wave periods. Then, material properties, as well as mass and stiffness matrices, are chosen to achieve this effect.