Browsing by Subject "dual"
Now showing 1 - 2 of 2
Results Per Page
Sort Options
Item A top-injection bottom-production cyclic steam stimulation method for enhanced heavy oil recovery(Texas A&M University, 2006-10-30) Matus, Eric RobertA novel method to enhance oil production during cyclic steam injection has been developed. In the Top-Injection and Bottom-Production (TINBOP) method, the well contains two strings separated by two packers (a dual and a single packer): the short string (SS) is completed in the top quarter of the reservoir, while the long string (LS) is completed in the bottom quarter of the reservoir. The method requires an initial warm-up stage where steam is injected into both strings for 21 days; then the LS is opened to production while the SS continues to inject steam for 14 days. After the initial warm-up, the following schedule is repeated: the LS is closed and steam is injected in the SS for 21 days; then steam injection is stopped and the LS is opened to production for 180 days. There is no soak period. Simulations to compare the performance of the TINBOP method against that of a conventional cyclic steam injector (perforated across the whole reservoir) have been made. Three reservoir types were simulated using 2-D radial, black oil models: Hamaca (9????API), San Ardo (12????API) and the SPE fourth comparative solution project (14????API). For the first two types, a 20x1x20 10-acre model was used that incorporated typical rock and fluid properties for these fields. Simulation results indicate oil recovery after 10 years was 5.7-27% OIIP with TINBOP, that is 57-93% higher than conventional cyclic steam injection (3.3-14% OIIP). Steam-oil ratios were also decreased with TINBOP (0.8-3.1%) compared to conventional (1.2-5.3%), resulting from the improved reservoir heating efficiency.Item Interpretation, Analysis and Design of Inter-well Tracer Tests in Naturally Fractured Reservoirs(2013-08-19) Alramadhan, Aymen AbduljalilIn order to understand the complex fracture network that controls water movement in Sherrod Area of Spraberry Field in West Texas and to better manage the on-going waterflood performance, a field scale inter-well tracer test was implemented. This test presents the largest inter-well tracer test in naturally fractured reservoirs reported in the industry and includes the injection of 13 different tracers and sampling of 110 producers in an area covering 6533 acres. Sherrod tracer test generated a total of 598 tracer responses from 51 out of the 110 sampled producers. Tracer responses showed a wide range of velocities from 14 ft/day to ultra-high velocities exceeding 10,000 ft/day with same-day tracer breakthrough. Re-injection of produced water has caused the tracers to be re-injected and added an additional challenge to diagnose and distinguish tracer responses affected by water recycling. Historical performance of the field showed simultaneous water breakthrough of a large number of wells covering entire Sherrod area. This research investigate analytical, numerical, and inversion modeling approaches in order to categorize, history match, and connect tracer responses with water-cut responses with the objective to construct multiple fracture realizations based entirely on water-cut and tracers? profiles. In addition, the research highlight best practices in the design of inter-well tracer tests in naturally fractured reservoirs through lessons learned from Sherrod Area. The large number of tracer responses from Sherrod case presents a case of naturally fractured reservoir characterization entirely based on dynamic data. Results indicates that tracer responses could be categorized based on statistical analysis of tracer recoveries of all pairs of injectors and producers with each category showing distinguishing behavior in tracers? movement and breakthrough time. In addition, it showed that tracer and water-cut responses in the field are dominantly controlled by the fracture system revealing minimum information about the matrix system. Numerical simulation studies showed limitation in dual porosity formulation/solvers to model tracer velocities exceeding 2200 ft/day. Inversion modeling using Gradzone Analysis showed that east and north-west of Sherrod have significantly lower pore volume compared to south-west.