Browsing by Subject "boundary layer transition"
Now showing 1 - 2 of 2
Results Per Page
Sort Options
Item An Examination of Configurations for Using Infrared to Measure Boundary Layer Transition(2012-10-19) Freels, Justin ReedInfrared transition location estimates can be fast and useful measurements in wind tunnel and flight tests. Because turbulent boundary layers have a much higher rate of convective heat transfer than laminar boundary layers, a difference in surface temperature can be observed between turbulent and laminar regions of an airfoil at a different temperature than the free stream air temperature. Various implementations of this technique are examined in a wind tunnel. These include using a heat lamp as an external source and circulating fluid inside of the airfoil. Furthermore, ABS plastic and aluminum airfoils are tested with and without coatings such as black paint and surface wraps. The results show that thermal conduction within the model and surface reflections are the driving issues in designing an IR system for detecting transition. Aluminum has a high thermal diffusivity so is a poor choice for this method. However, its performance can be improved using an insulating layer. Internal fluid circulation was far more successful than the heat lamp because it eliminates the reflected IR due to the heat lamp. However, using smooth surface wraps can mitigate reflection issues caused by the heat lamps by reducing the scatter within the reflection, producing an IR image with fewer contaminating reflections.Item Design of an Instrumentation System for a Boundary Layer Transition Wing Glove Experiment(2012-08-23) Williams, Thomas 1987-Laminar flow control holds major promise for increasing aircraft efficiency and increasing laminar flow over aerodynamic surfaces could decrease drag by up to 30 percent. The Flight Research Lab at Texas A&M University has studied laminar flow over a wing with 30 degrees of leading edge sweep with Discrete Roughness Elements (DREs) installed and has indicated that DREs can be used to increase laminar flow at Reynolds numbers up to 7.5 million at Mach 0.3. A new project, termed SARGE, has been commissioned in conjunction with NASA for studying DREs on a swept wing glove at conditions relevant to jet transports. The SARGE project must have an instrumentation system capable of accurately measuring flow conditions and transition location on the suction side of the glove. Infrared (IR) thermography has been selected as the primary transition detection tool. A heat transfer analysis has shown that solar radiation will warm the surface of the glove above the adiabatic wall temperature and therefore the laminar region will appear to be warmer. The FLIR SC8000 IR camera has been selected for this application due to its ability to produce high-resolution images in the appropriate IR band. High quality air data is also required for the experiment. A five-hole probe will be used to measure flow angle and velocity near the glove. This instrument will provide meanflow conditions due to its limited frequency response. High quality pressure transducers coupled with careful probe calibration will allow for differential measurements to be made with an uncertainty of +/- 0.03 degrees. Static pressure ports and high frequency response Kulite transducers will also be employed. Hotfilm sensors will be used to verify the state of the boundary layer on the glove through spectral analysis. A unique hotfilm array has been proposed that will enable the measurement of traveling wave vectors through a spectral technique. An experiment on the Flight Research Lab's Cessna O-2 to investigate the veracity of this technique has also been suggested. Thermocouples will also be installed on the glove's surface to monitor temperatures and verify transition location. The layout of the hotfilms and thermocouples is also detailed.