Browsing by Subject "absorption spectroscopy"
Now showing 1 - 2 of 2
Results Per Page
Sort Options
Item Measurement of Water Vapor Concentration using Tunable Diode Laser Absorption Spectroscopy(2010-07-14) Barrett, Alexander B.Tunable diode laser spectroscopy and the Beer-Lambert relation has been used to measure the absorption of water vapor both in an absorption cell and in a shock tube. The purpose of this thesis is to develop a laser diagnostic capable of determining species concentration. The correlation between species concentration and absorption is known, and if one is known the other can be calculated. A diode laser was obtained which has a tunable range of 1325.7 - 1400.8 nm and is centered at 1384 nm. An experimental setup was created in which the laser was used to obtain absorption spectroscopy data for water vapor within two separate scenarios- in an absorption cell and in a shock tube. A model was constructed which enabled the calculation of the Voigt profile which in turn was used to determine the absorption coefficient and ultimately enable the utilization of absorption spectroscopy principles to determine species concentration and/or absorption percentage. The experiments for the absorption cell were performed at room temperature. Twenty runs were performed and the average error for all runs was less than one percent. Three runs were performed for the shock-tube experiments. The absorption was calculated at three times- prior to the arrival of the shock, after the incident shock passed, and after the reflected shock passed. The temperatures for these conditions were 296K, 1060K, and 2000K respectively. These experiments showed reasonable agreement with theoretical calculations.Item The development and application of a diode-laser-based ultraviolet absorption sensor for nitric oxide(Texas A&M University, 2004-09-30) Anderson, Thomas NathanThis thesis describes the development of a new type of sensor for nitric oxide (NO) that can be used in a variety of combustion diagnostics and control applications. The sensor utilizes the absorption of ultraviolet (UV) radiation by the NO molecule to determine the concentration via optical absorption spectroscopy. UV radiation at 226.8 nm is generated by sum frequency mixing the outputs from a 395-nm external cavity diode laser (ECDL) and a 532-nm diode-pumped, intracavity frequency doubled Nd:YAG laser in a beta-barium borate (BBO) crystal. This radiation is used to probe the (v'=0, v"=0) band of the ?*?+ - ?*? electronic transition of NO. The ECDL is tuned so that the UV radiation is in resonance with a specific energy level transition, and it is then scanned across the transition to produce a fully resolved absorption spectrum. Preliminary experiments were performed in a room-temperature gas cell in the laboratory to determine the accuracy of the sensor. Results from these experiments indicated excellent agreement between theoretical and experimental absorption line shapes as well as NO concentrations. Further experiments were performed at two actual combustion facilities to demonstrate the operation of the sensors in realistic combustion environments. Tests on a gas turbine auxiliary power unit (APU) at Honeywell Engines and Systems and on a well-stirred reactor (WSR) at Wright-Patterson Air Force Base produced excellent results despite the harsh temperatures and vibrations present. Overall, the sensitivity was estimated to be 0.8 parts per million (ppm) of NO (at 1000 K) for a 1 meter path length and the measurement uncertainty was estimated to be ?10%.