Browsing by Subject "BICS"
Now showing 1 - 2 of 2
Results Per Page
Sort Options
Item Power supply partitioning for placement of built-in current sensors for IDDQ testing(Texas A&M University, 2004-09-30) Prasad, AbhijitIDDQ testing has been a very useful test screen for CMOS circuits. However, with each technology node the background leakage of chips is rapidly increasing. As a result it is becoming more difficult to distinguish between faulty and fault-free chips using IDDQ testing. Power supply partitioning has been proposed to increase test resolution by partitioning the power supply network, such that each partition has a relatively small defect-free IDDQ level. However, at present no practical partitioning strategy is available. The contribution of this thesis is to present a practical power supply partitioning strategy. We formulate various versions of the power supply partitioning problem that are likely to be of interest depending on the constraints of the chip design. Solutions to all the variants of the problem are presented. The basic idea behind all solutions is to abstract the power topology of the chip as a flow network. We then use flow techniques to find the min-cut of the transformed network to get solutions to our various problem formulations. Experimental results for benchmark circuits verify the feasibility of our solution methodology. The problem formulations will give complete flexibility to a test engineer to decide which factors cannot be compromised (e.g. area of BICS, test quality, etc) for a particular design and accordingly choose the appropriate problem formulation. The application of this work will be the first step in the placement of Built-In Current Sensors for IDDQ testing.Item Voltage sensing based built-in current sensor for IDDQ test(Texas A&M University, 2006-04-12) Xue, BinQuiescent current leakage test of the VDD supply (IDDQ Test) has been proven an effective way to screen out defective chips in manufacturing of Integrated Circuits (IC). As technology advances, the traditional IDDQ test is facing more and more challenges. In this research, a practical built-in current sensor (BICS) is proposed and the design is verified by three generations of test chips. The BICS detects the signal by sensing the voltage drop on supply lines of the circuit under test (CUT). Then the sensor performs analog-to-digital conversion of the input signal using a stochastic process with scan chain readout. Self-calibration and digital chopping are used to minimize offset and low frequency noise and drift. This non-invasive procedure avoids any performance degradation of the CUT. The measurement results of test chips are presented. The sensor achieves a high IDDQ resolution with small chip area overhead. This will enable IDDQ of future technology generations.