Preliminary analysis of doubler plate attachment details for steel moment resisting frames

In steel moment resisting frames, the region of the column located within the beam-column joint is known as the panel zone. When a steel moment resisting frame is subjected to lateral load, due to wind or seismic loads, the panel zone is subject to high shear. In some cases, the shear in the panel zone is sufficiently high that the panel zone must be reinforced to increase its stiffness and/or strength. This is normally accomplished by welding doubler plates to the column in the panel zone region. Doubler plates can be a costly feature in steel moment resisting frames because of the substantial amount of welding involved. There has been a large amount of past research that has investigated the required shear strength and stiffness of the panel zone region to establish a basis for sizing doubler plates. However, very little past research has investigated the details of attaching doubler plates to columns. These attachment details can have a significant influence on the structural performance of panel zone and on cost. The overall goal of this research was to conduct preliminary finite element studies that provide insight into several key issues related to the attachment of doubler plates to columns and to identify issues that require further research. The research involved finite element modeling of a simplified representation of beam-to-column joint subjected to monotonic loading. A total of twenty-one analysis cases with different doubler plate attachment details were studied. Issues that were investigated included the effect of welding different edges of the doubler plate to the column (horizontal edges only, vertical edges only, and all four sides), the effect of extending the doubler plate beyond the panel zone region, and the effect of providing two thinner doubler plates of equivalent total thickness on both sides of the column web instead of one thick doubler plate on one side of the column web. In addition, the forces developed in the doubler plate welds were computed from the finite element analysis and compared with current building code requirements for the design of these welds. Observations and preliminary design recommendations on these issues are provided in this thesis, along with recommendations for further research.