Surface Modification of LiNi0.5Mn0.3Co0.2O2 Cathode for Improved Battery Performance

Date

2012-10-19

Journal Title

Journal ISSN

Volume Title

Publisher

Abstract

This thesis details electrical and physical measurements of pulsed laser deposition-applied thin film coatings of Alumina, Ceria, and Yttria-stabilized Zirconia (YSZ) on a LiNi0.5Mn0.3Co0.2O2 (NMC) cathode in a Lithium ion battery. Typical NMC cathodes exhibit problems such as decreased rate performance and an opportunity for increased capacity exists by raising operation voltage beyond the electrolyte stability window. Very thin (~10 nm) coatings of stable oxides provide a pathway to solve both problems. As well, the electrochemical impedance spectra of the uncoated and coated cells were measured after different numbers of cycles to reveal the property variation in the cathode. Further understanding of the mechanism of rate performance enhancement and chemical protection by thin oxide coatings will continue to improve battery capability and open up new applications.

Ceria-coated Li-NMC cells show the best capacity and rate performance in battery testing. Through electrochemical impedance spectroscopy (EIS), the surface film resistance was found to remain stable or even drop slightly after repeated cycling at high voltage. CeO2 is proposed as a coating for Lithium ion battery cathodes owing to its high chemical stability and the demonstrated but not yet well understood electrical conductivity. Alumina-coated cathode shows comparable performance as that of the uncoated cell in the early stage of the test, but through the course of testing the rate capability and recoverable capacity is improved. This is possibly due to Al2O3?s well-known abilities as HF scavenger and chemically inert nature. YSZ-coated cathode performs worse than the uncoated ones in terms of capacity, rate capability, and EIS-related figures of merit. The reason for the poor performance is not yet known, and repeatability tests are under way to verify performance. High voltage cycling reveals no obvious difference in irreversible loss between the coated or uncoated cells. The reason for the lack of distinction could be the relatively small percentage of surface coating compared to the thick doctor-blade processed cathode layer.

Description

Citation