Adapting a Beam-Based Rotordynamics Model to Accept a General Three-Dimensional Finite-Element Casing Model

Date

2011-08-08

Journal Title

Journal ISSN

Volume Title

Publisher

Abstract

The subject of this thesis is an extension of a two-dimensional, axisymmetric, Timoshenko-beam finite-element rotordynamic code to include a three-dimensional non-axisymmetric solid-element casing model. Axisymmetric beams are sufficient to model rotors. Spring and damper forces provide the interface between the rotor and its casing and capture the dynamics of the full model. However, axisymmetric beams limit the modeling of real-case machine structures, where the casing is not axisymmetric. Axisymmetric and non-axisymmetric 3D finite element casing structures are modeled. These structures are then reduced using a technique called substructuring. Modal equations are developed for axisymmetric and non-axisymmetric casing models. In a 3D non-axisymmetric model, structural dynamics modes can be modeled by lateral modes in two orthogonal planes. Modal information of the complex 3D casing structures are generated, and then incorporated into the 2D code after a series of pre-processing steps. A reduction method called Component Mode Synthesis (CMS) is used to reduce the large dimensionality involved in calculation of rotordynamic coefficients. The results from the casing structures are merged with the rotor model to create a combined rotor-casing model. The analysis of the combined structure shows that there is a difference in the natural frequencies and unbalance response between the model that uses symmetrical casing and the one that uses non-axisymmetric casing. XLTRC2 is used as an example of a two-dimensional axisymmetric beam-element code. ANSYS is used as a code to build three-dimensional non-axisymmetric solid-element casing models. The work done in this thesis opens the scope to incorporate complex non-axisymmetric casing models with XLTRC2.

Description

Citation